This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| user_guide:zbt:openwrt_zbt_apg621 [2021/03/10 06:25] – [Introduction] admin | user_guide:zbt:openwrt_zbt_apg621 [2021/03/10 06:50] (current) – [The Interface] admin | ||
|---|---|---|---|
| Line 10: | Line 10: | ||
| * https:// | * https:// | ||
| - | ===== Instructiions | + | ===== Instructions |
| + | * We assume that you have some form of the DB120 OpenWRT firmware. | ||
| + | * The device has a very handy bootloader called BREED. | ||
| + | * To get the bootloader in flash mode you can do the following. | ||
| + | * Connect the device to a computer which is on the 192.168.1.x sub-net. (e.g. give your computer an IP of 192.168.1.10) | ||
| + | * Run a continuous ping to 192.168.1.1. | ||
| + | * **Before** applying | ||
| + | * The device should start answering pings after ~15seconds. | ||
| + | * Now you can release the reset button. | ||
| + | * Go to your browser and enter the following URL | ||
| + | * http:// | ||
| + | ==== The Interface ==== | ||
| + | * Unfortunately the UI is in Chinese so you have to ' | ||
| + | {{ : | ||
| + | |||
| + | * Select the second item on the left hand side | ||
| + | * Select the item **under** Bootloader on the main page and pick your firmware file | ||
| + | * Keep the check mark and click the only button (We assume it says something like upload) | ||
| + | * It will submit the firmware and the next screen will give some info on the firmware | ||
| + | |||
| + | {{ : | ||
| + | |||
| + | * Click the button at the bottom to start flashing | ||
| + | |||
| + | {{ : | ||
| + | |||
| + | * You will see a progress bar that will give an indication how the procedure progresses. | ||
| + | |||
| + | {{ : | ||