This is an old revision of the document!
Table of Contents
Steps to flash and configure your Router to work with MESHdesk
These are the steps we will take to get your system working on Meshdesk:
- Buy a supported router. The list of supported routers are here- Supported hardware
- Download the latest firmware for your router from sourceforge.net here- https://sourceforge.net/projects/radiusdesk/files/MESHdesk/
- Start-up Your router in fail-safe mode
- Flash the latest MESHdesk firmware onto your router
- Download the latest Meshdesk Node Config Utility from here- https://sourceforge.net/projects/radiusdesk/files/MESHdesk/
- Configure the router with the MESHdesk Node Config Utility
- Each type of hardware has a unique way to get the firmware installed onto the device.
| Hardware | Instructions |
|---|---|
| Dragino | http://wiki.dragino.com/index.php?title=Web_FailSafe_Uboot |
| OpenMesh OM2P | http://help.cloudtrax.com/hc/en-us/articles/202210960-How-to-manually-flash-firmware-on-a-CloudTrax-enabled-access-point |
| Ubiquity PicoStation HP | http://www.radiusdesk.com/user_guide/chilli/ubiquity_basic#flashing_openwrt_onto_the_picostation2 |
How to Flash and Configure a ZBT WE2026
Start-up Your router in fail-safe mode
To start-up the ZBT we2026 in fail-safe mode:
- Hold in the reset button.
- While holding in the reset button, plug in the power cable.
- While the power cable is plugged in, release the reset button.
- The LED's will flash quickly to indicate that the device is in fail-safe mode.
